General
The ED2 Series SkidWeigh lift truck on-board check weighing system sets a new standards in performance, technology and design thanks to it's modular concept and innovative system component and software which can be easily integrated into variety of material handling vehicles.
These compact systems meet the highest specifications for mechanical stress, EMC compatibility and operational reliability and are suitable for all demanding material handling vehicles applications.
These compact systems meet the highest specifications for mechanical stress, EMC compatibility and operational reliability and are suitable for all demanding material handling vehicles applications.
Technical
ED2 Digital indicator
- Measuring range to up to 50000 pounds or kg
- Operating temperature -25 C to +70 C
- Operating voltage from 12 to 55 VDC
- Current consumption < 80mA
- Technology, Micro controller
- Web based wireless reporting interface (Exceptions reports)
- Accuracy within +/- 0 to 1% of vehicle lifting capacity
- Additional weighing channel
- Visual overload warning
- Weighing resolution 1,5,10,25
- % load weight capability
- Under utilization count down timer
- Impact detection visual warning
- Impact detection count down timer
- Adjustable time down timer
- Accumulative load weight total
- LED display 6 digits, large size 14 x 8 mm
- Bright red display intensity
- Optimum viewing angle +/- 60 degree from operator's line of sight
- Housing, ABS NEMA Type 4X, size 120 x 80 x 55 mm
- Liquid tight straight-thru fitting for electrical cable
- RS-232 interface
- Output relay S.P.D.T.
- Weight approx. 425g (Without mounting bracket)
Pressure transducer
- Pressure transducer port 1/4"-18 NPT male thread
- Built in pressure snubber
- Proof pressure, 2.5 x range or 6000 PSI
- Environmental: NEMA 4X
- Electrical plug connector, M12 x 1 metal thread, protection IP65
- UL Standard 873
- Shock IEC 60068-2-27
- Vibration IEC 60068-2-6
- Power supply 8 to 33 V DC
- Insulation voltage 500 V DC
- Response time < 1ms
- Load cycle < 100 Hz
- Current consumption 4 mA
- Reverse polarity protection
- Over voltage protection
- Short circuit protection
- Housing material, Stainless steel (AISI 303)
- Weight 95 g
- Installation, unrestricted
- EMC Conformity EN 61326-2-3:2006 pressure sensor
- Negligible temperature influence on accuracy
- No media egress when exceeding rapture pressure (Patented)
- Swiss Made pressure transducer
Solutions
The ED2 Series SkidWeigh system is general application, fully automatic microprocessor electronic device that measures the load weight on typical material handling vehicle.
The ED2 Series SkidWeigh can be installed on any lift truck, regardless of the vehicle make, model or operating voltage having a maximum lifting capacity to up to 50000 pounds or kg.
Standard installation of the pressure transducer is between lift control valve and lifting cylinder. Two button calibration is automatic and consist of lifting the empty and loaded forks above the ground.
The ED2 Series SkidWeigh can be installed on any lift truck, regardless of the vehicle make, model or operating voltage having a maximum lifting capacity to up to 50000 pounds or kg.
Standard installation of the pressure transducer is between lift control valve and lifting cylinder. Two button calibration is automatic and consist of lifting the empty and loaded forks above the ground.
Advantages
* System will not reduce lifting capacity of the vehicle
* No operator input required to use the system
* Fully automatic, just lift the forks and weigh the load
* No additional hardware required (proximity switches, push buttons, etc.)
* Easy installation, can be done by the end user
* Simple two button automatic calibration
* Over 100 software configurations for all kinds of material handling vehicles
* Quick round the clock exchange program service
* Two years warranty
* Economically priced